Name: Dongar PRO Parking Mode Adapter
Brand: Dongar
SKU: DONGAR-PMA-01
Price: 93.0 CAD
Availability: InStock

EFFORTLESS INSTALLATION, ENHANCED POWER

Upgraded with powerful features like parking mode and low-voltage protection, the Dongar PRO offers the same easy installation as our classic adapter.

Learn more about the PRO Learn more about installation

What's included:

▸ Dongar PRO USB Module

▸ Toyota Cable Pack (3 wiring harnesses)

▸ Shorty USB cables to connect to any USB-powered device

* To power your dash cam, you'll also need a micro SD card.

Included harnesses: Toyota Cable Pack

5-PIN
For roof-cavity installs in the new Tacoma, Land Cruiser, 4Runner, and more.
10-PIN
For rearview mirror installs in the new Tacoma, Land Cruiser, 4Runner, and more.
12-PIN
For rearview mirror installs in older models of the Tacoma, Tundra, Sienna, and more.

View full compatibility

HOW TO INSTALL

Roof-Cavity Installation Rearview Mirror Installation

Roof-Cavity Install:

Remove the domelight assembly by placing your fingers at the front of the assembly (closer to windshield) and gently pulling down.
Locate the 5-pin connector port within the domelight cavity and connect the 5-Pin PRO harness to it. Route the 3-pin end of the same harness through the headliner.
Connect the 3-pin head to the Dongar PRO USB module and plug your dash cam in to the USB-C port. Turn [ON] your vehicle and ensure the dash cam is receiving power.
Once you have confirmed the dash cam is receiving power, mount the dash cam and PRO adapter on a clean spot on the windshield and re-assemble the plastic shroud.

Rearview Mirror Install:

Tilt your mirror down for easier access to the back of the rearview mirror. (If your rearview mirror is shrouded, this will also provide better access to the shroud. To remove the shroud, place your fingers between the headliner and smaller panel piece and pull straight down. The larger panel can be removed by sliding it down and away from you.)
Locate and unclip the mirror's connector. Then, plug the matching (either 10-Pin or 12-Pin) male end of the PRO harness into the mirror's female port.
Plug the male end of the original mirror connector into the female end of the PRO harness. Plug the smaller 3-pin head into the PRO USB module.
Connect your dash cam to the USB-C port on the PRO module. Turn [ON] your vehicle and ensure the dash cam is receiving power. Once you have confirmed the dash cam is receiving power, mount the dash cam and PRO adapter on a clean spot on the windshield.
Route the cables accordingly and re-assemble the plastic shroud.